Main FAQ Page -- SSi Website

 

The SDS program is not starting on the 8120/8140 screen. What do I do?

 

NOTE: This solution involves removing the electronics from the case. Do so in a safe environment.

 

1. Make sure the unit is turned off.

2. Remove the four screws from the underside of the case. Place them in a secure location.

3. Pull the electronics package from the case and set at an angle so it does not fall back in.

4. Look on the back side of the screen (closest to the lid of the case) and find the grey lid cover.

5. Inside the cover is the SD card with the SDS program. Carefully pull the card out and reinsert it into the screen and close the grey lid.

6. Turn the unit back on. If the program starts, place the electronics package back into the case and replace the four screws.

7. If the program does not start, call SSi for additional help.